The K-20 system of a bracket K-28 of 800 mm for connection of conveyor tapes 800 mm of TsENTROBELT wide
- Customer pickup,
- In detail
Set of brackets of K-28 for connection of conveyer belts 800 mm wide
Wire brackets with a corrosion-resistant zinc coating of TsENTROBELT
- a set of 8 cartridges on 200 mm
- soyediniteliny core of K20
Demountable mechanical connectors of K-28 for joining of conveyer belts from 10 to 13 mm thick
Are intended for joining of conveyer belts with the durability up to 1000 N/mm
The K-27, K-28 type is design feature of mechanical connectors of the K-20 series a way of connection of the mechanical hinge with the conveyer belt - by means of the chetyrekhzhalny steel wire brackets of small diameter connected among themselves in strips 200 mm long by means of wire crossing points. Such design provides the sparing influence on a cord of the conveyer belt and, as a result, the increased dynamic durability of butt connection and the minimum impact of a joint on lining of a drum and elements of a design of the conveyor.
Wire brackets are made of a special steel wire with an anticorrosive covering.
Connectors of the K-20 series are issued two types:
the K-27 type for tapes 7-11 mm thick
the K-28 type for tapes 10-13 mm thick
Brackets of K28 are pressed in the ends of the joined tapes by means of the special lever device then both parts of a joint connect by the principle of "lock lightning", i.e. brackets of one end of a tape are located between brackets of another, and in loops the connecting core of K20 is entered.
The connecting core of K-20 for K-28 represents a piece of a rope of a special design with special seal of the ends which length depends on width of the joined conveyer belt.
Length of a connecting core of K-20, mm - 785, 985, 1185, 1385, 1585.
Connectors of K-27, K-28 are delivered in a set on width of the joined tape 1200 mm - 12 strips on 200 mm, in this regard when joining a tape connectors can be gathered on any width of a tape.
Advantages of connectors of the K-20 series. K-27, K-28 TsENTROBELT type
– by preparation for joining of a tape the technology becomes simpler, tape facings, simple cutting of a tape at right angle by means of a square do not exfoliate;
– flexibility of the received joint same, as integral tape that does not create tension when passing by a tape of drums;
– the tape, identical on all thickness, will not complicate passing on clearing devices;
– dismantle and installation of a tape cloth in any place becomes simpler;
– the share of manual skills (mechanization of works) in connection with use of the tool decreases.
TsENTROBELT-we connect tapes