Mechanical connectors of RShM - analogs: butt connection Vulcan Krug 120/1600, connectors of PVS-1, STOK
- 16 UAH/pcs - from 10000 pcs
- Customer pickup,
- In detail
Set of the RShM 120/1600 mechanical butt connection an analog "Volcano" - the Circle 120/1600
LLC TSENTROBELT ODESSA is a producer of mechanical connectors for the loaded conveyer belts (production of crushed stone, extraction of clay, sand, production of concrete, building materials)
- urgent joining of the conveyer belt
- longitudinal cut
- cross cut
- the breakdown of a tape caused by falling of material or mechanical damage
- stratification of the vulcanized and stuck together butt connections
THE IDEAL DECISION ON THE BEST PRICE IS NECESSARY?
Use a simple product which will approach all types of conveyer belts!
Mechanical connectors of RShM for joining and repair of conveyer belts
THE BEST PRICE AMONG ALL EXISTING ANALOGUES
from only 13, 20 UAH/piece including VAT
15,00 UAH/piece including VAT – retail
HOW MUCH FOR TO CONNECT THE TAPE OUR CONNECTORS?
At the minimum scheme for tapes with small loading:
tape 1000 mm wide = 32 pieces of connectors of RShM x 15,00 = 480,00 UAH.
* for the high-loaded tapes strong schemes of joining are offered
HOW MUCH FOR TO REPAIR THE LONGITUDINAL CUT MECHANICAL CONNECTORS OF RSHM:
1000 mm of a cut = 32 pieces of connectors of RShM x 15,00 = 480,00 UAH.
The mechanical connector of RShM is intended for connection of conveyer belts with layer-by-layer cutting, as at cold/hot curing, but with the reduced joint length. This way of joining is successfully fulfilled and perfectly Beshtak (Poland - connectors proved on connectors of production of firm the DRAIN), and then APO Styk (the Russian Federation, connectors Vulcan, Vulcan Circle) and has a number of advantages:
1) Joint durability on a gap at the correct installation of connectors reaches up to 2000 kN/m.
2) The joint is tight – there is no prosypaniye of the transported material
3) Acquisition of the special tool is not required – installation is possible even by means of manual rotation (for convenience and saving of time it is recommended to use pneumo - or electro-gaykovert)
Joining of a tape by means of mechanical connectors of RShM differs in reliability and durability. Connection consists of two clamping punched washers of a special form, in lower durability high-class nut is pressed. The clamping washers which are pulled together among themselves by the M6x50 screw with the durability of 10,9 TORX T30 provide the most dense compression of a tape as a clamp.
MECHANICAL CONNECTORS OF RSHM, IN DIFFERENCE FROM ALL ANALOGUES KNOWN TO US, HAVE THE LOWEST PROFILE THANKS TO WHAT UTAPLIVATSYA IN THE TAPE FACING THAT PREVENTS WEAR OF BUTT CONNECTION, ROLLERS, SCRAPERS.